Related Topics:
Instructions Preparing Camera Ready-
FieldMate Optical Power Meter Usage Instructions
Access the Coherent FieldMate Laser Power Meter, LM-thermopile, OP-2 IR, OP-2 VIS, OP-2 UV, PM10, PM10K, PM150, PM2, PM3 User Manual with AI-powered Q&A and PDF download. Wilsonville, OR 97070 FieldMate User Manual ii This document is copyrighted with all rights reserved. Under the copyright laws, this document may not be copied in whole or in part or reproduced in any other media without the express written. This manual contains user information for the FieldMateTM laser power meter. It is the policy of Coherent to comply strictly with U. In some. This latest member of Coherent's power meter line-up combines both a steady digital display and fast analog meter to provide the most economical way to make power measurements. Refer to. REF/dB key: Short press the dB to switch unit, click once nW/dBm/dB to enter the upper clear data, press and hold until REF is displayed on the screen, and set the current optical power as reference value, enter the relative optical power test mode, the screen will display the setted reference.
[PDF Version]
-
JBC-11 Relay Protection Tester Usage Instructions
The steps for operating a relay protection tester can be divided into the following stages: ✅ Preparation: ⇨Make sure the tester is connected to a 220V AC power supply and is reliably grounded. ⇨Start the tester, select "I accept" and confirm, and wait for the system to. The JBC, JBCG and JBCV relays consist of three units, an instanta-neous power-directional unit (bottom) of the induction-cup type, a time overcurrent unit (middle) of the induction-disk type, and an instantaneous-over-current unit (top) of the induction-cup type. The instrument uses single-chip microprocessor technology over the same period by the number of milliseconds the table automatically, logic control unit, multi-function digital display. The yellow, green, red and black terminals on the panel of the relay protection tester are the voltage output terminals of the instrument. There is a DC output and power connection on the back of the panel.
[PDF Version]